SMA
Technologie AG
1.1.3 Installation (B): Antenna, Piggy-Back ex Factory
If the Radio Pigy-Back has already been installed at the factory, the antenna can be
fastened to the inverter as follows.
This chapter is intended solely for qualified electricians!
All work on the inverter may only be performed by qualified electricians!
Please
follow
documentation!
1.
Remove the protective cap from the thread of the antenna
on the inverter housing.
2.
Plug the sealing on the thread of the
antenna on the inverter housing.
3.
Screw the antenna tip to the thread of
the antenna on the inverter housing.
all
safety
instructions
Installing a Radio Piggy-Back in an Inverter
contained
in
BEAMPBNR-BXX072623
the
inverter
15