Leveling The Unit - mabe RMF0411PYMNO Instructivo

5. Remove the two screws from the upper bracket and then place
them on the opposite side. Before doing so, remove the plastic
cap on the other side.
6. Slide the appliance door towards the top hinge. Make sure it is in
the right direction. Screw the lower hinge into its new position.
Replace the leg on the other side. Install the plastic cap of the
door hinge. It will snap into place.
7. Make sure that the door is aligned both horizontally and verti-
cally, and that the door gasket contacts all surface before tighten-
ing the lower hinge. Adjust the leveling legs again.

leveling the unit

To perform this, adjust the two leveling legs on the front of the
unit.
If the unit is not level, the door and the magnetic gasket will not be
covered correctly.
19