Quick Guide For Menu Operation - Hitachi M24G1 Guia Del Usuario

CH
/
Press and release CH / . The TV automatically stops at the
next channel.
For proper operation, before selecting channels, they should be
set into the memory. See "Channels setup" on page 19.
INFO
Press INFO to display the current information on the screen.
When the TV receives a digital signal, the digital information will
appear.
• Channel number
• Channel label (if preset)
• Parental Control
• Program guide
• Resolution
Press INFO again to clear the display.
MUTE
Press MUTE to switch off the sound. The TV's sound will be
silenced and MUTE icon will appear on the screen. The sound can
be switched back on by pressing this button again or by pressing
the VOL (VOLUME ) + or – buttons.
SLEEP
To set the TV to turn off automatically after a preset amount of
time, press SLEEP on the remote control. The clock will change
for each press of the SLEEP button (Off, 5 min, 10 min, ..., 240
min).
To confirm the sleep timer setting, press SLEEP and the remaining
time will be displayed for a few seconds. To cancel the sleep timer,
press SLEEP repeatedly until the display turns to Off.
• DTV Signal condition
• Broadcast program name
• Close Caption Display
• Current date and time
• Audio language
Quick guide for menu
operation
Example: Select Menu Language.
1
Press INPUT to select TV mode.
2
Press MENU. The TV menu screen will appear.
3
Press ◀ or ▶ to select "Setup", then press ▼.
4
Press ▲ or ▼ to select "Menu Language", then press ◀ or ▶
to select the desired language.
5
Press EXIT to return to the normal screen.
NOTE:
• On the following pages, the menu can be called in the same way
described above, by pressing the MENU button.
• If no buttons are pressed for more than about 15 seconds
(depending on your setting), the TV will return to normal viewing
automatically.
• During TV or external input mode (except PC input mode), if
there is no signal reception, the TV will change to standby after
approx. 15 minutes (in PC input mode: 1 minute).
15 EN