Getting Started; Bluetooth Pairing - Lenco SBW-800 Manual Del Usuario

Getting Started:

1: Make sure you have made all the necessary cable connections
before connecting the Soundbar to a wall outlet, when connected
to the wall outlet, the soundbar will enter the standby mode and
the power indicator wil light up red.
2: Make sure the subwoofer is connected to the power and turn the
button to "ON"
3: Short press
to turn on the soundbar. The power indicator will light up white
4: Press the source button on unit or remote control to choose the
desired input source.
Note: The Soundbar will enter the standby mode if there is no
active input signal for 15 minutes.
Pair with the subwoofer
The wireless subwoofer automatically connects with the soundbar
when both units are powered on. If the subwoofer is on and
connected, the red LED will be lit continuously.
Note: For troubleshooting connection problems, refer to the trouble
shooting section

Bluetooth Pairing:

1: Short press the Source button on the Soundbar and choose the
Bluetooth input (voice "Bluetooth").
2: The indicator light will be flashing slowly to indicate it is searching
for a Bluetooth device.
3: Long press the Pair button on the side of the unit. The power
indicator will start to flash quickly.
/SOURCE on the unit or
11
on the remote control