Lcd Tv Components; Front; Jacks - Dynex DX-LCDTV19 Manual Del Usuario

LCD TV components

16 If an outside antenna or cable system is connected to your LCD TV,
make sure that the antenna or cable system is grounded to
provide some protection against voltage surges and built-up static
charges. Article 810 of the National Electrical Code, ANSI/NFPA No.
70, provides information with respect to correct grounding of the
mast and supporting structure, grounding of the lead-in wire to
an antenna discharge unit, size of grounding conductors, location
of the antenna-discharge unit, connection to grounding
electrodes, and requirements for the grounding electrode.
1
1 Electric service equipment
2 Power service grounding
electrode system
3 Ground clamps
4 Grounding conductors
5 Antenna discharge unit
6 Grounding clamp
7 Antenna lead-in wire
LCD TV components

Front

# Component
1 INPUT
2 MENU
3 VOL–/VOL+
4 CH–/CH+
7
5 POWER
6
6 Power LED
5
4
3
2
7 Remote sensor

Jacks

#
1
2
3
Description
Press to select the video mode.
You can select TV, Composite,
S-Video, VGA, Component, or
HDMI.
Press to open the on-screen
menu.
Press to decrease or increase
the volume.
Press to go to the previous or
next channel.
Press to turn your LCD TV on or
off.
Lights when your LCD TV is
turned on. When your LCD TV
is in standby mode, the LED is
red. When your LCD TV is on,
the LED is green.
Receives signals from the
remote control. Do not block.
Jack Description
Headphone Plug headphones into this jack.
AUDIO IN/VIDEO IN Plug an audio cable into the
left and right audio jacks to
provide sound for a standard
A/V device, and S-Video device,
or a component video device.
Plug a video cable into the
video jack a standard A/V
device.
COMPONENT IN Plug a component video
device into these jacks.
3