How To Operate Your Friedrich Room Air Con Di Tion Er; To Start Unit; To Set Mode Of Operation; Moneysaver ® Feature - Friedrich X-Star XQ05 Guia De Funcionamiento

How to operate your friedrich room air con di tion er

2 3 4
8 9
13
10 11 12
Figure 3

To start unit

If your air conditioner is installed and plugged into a
proper re cep ta cle, it is ready to go. The first time the unit
is started, the compressor will delay for three minutes.
See Automatic Component Protection, Page 5.
1 Touch the POWER ON/OFF button once. The unit
will automatically be in COOL with the temperature
set at 75 ° F (24 ° C) and the fan speed at F1, the sleep
setting.

To set mode of operation

When you fi rst turn the unit on, it will be in the COOL
mode (light on,) with constant fan.
2 Touch the MODE button once to activate the
®
MoneySaver (light on.)
®
MoneySaver is a feature that cycles the fan with the com-
pres sor so that the fan does not run all the time. This saves
4
920-115-05 (11-04)
Fan
Mode
Speed
Timer Set
Hour
On/Off
energy and improves de hu mid i fi ca tion. MoneySaver
also run to test the temperature if the off cycle is too long.
Or you may prefer con stant fan for more air move ment.
(To return to constant fan, touch the MODE button two
more times.)
In order to run the fan by itself, do the following:
3 Continuing from MoneySaver
the MODE button once to activate the FAN ONLY
feature (light on.)
The FAN ONLY setting will circulate air in the room
without the compressor coming on. This feature can also
be used in conjunction with the EX HAUST / VENT SHUT
lever to remove stale air or smoke. See page 7, EXHAUST
CONTROL, for more information.
1
6
7
5
®
will
® mode (light on,) touch