Kohler K-705700 Guia De Instalacion página 17

Trim the seal at the
hinge bracket so door
opens without snagging
the seal.
12. Install the Bottom Track Seal
CAUTION: Risk of product damage. Do not install the threshold seal under the hinge or the door
will not operate properly.
NOTE: If needed, apply a small amount of water or petroleum jelly to lubricate the seal when sliding it
into place.
Starting at the strike jamb side, install the threshold seal into the groove of the bottom track.
Position the seal so it is even with the end of the track.
Notch the foam portion around the strike jamb on 30" (76.2 cm) - 48" (121.9 cm) models or the glass
to glass seal on 60" (152.4 cm) doors.
Carefully trim the excess seal at the door hinge with a scissors or knife, confirming that when the
panel is opened/closed the hinge does not snag the seal.
Kohler Co.
Threshold Seal
Bottom
Track
17
Strike
Jamb Seal
Trim around strike seal.
1064866-2-B