Door, Door-Hinges And Front Of The; Appliance; Mica Covers; Troubleshooting - Teka MS 620 BIS Guía De Uso

accessories may be washed in the
dishwasher. Ensure that the rotating
plate and respective base are always
clean.
Door, door-hinges and

appliance

1. These parts must always be clean,
especially the
between the door and the front of the
appliance, so that there are no leaks.
2. To clean, use a neutral detergent and
lukewarm water. Dry with a soft cloth.

Mica covers

Always keep the mica covers clean. Food
remaining in the covers may deform it or
The appliance does not function properly:
 Is the power plug correctly inserted in the
socket?
 Is the door properly closed? The door
should make an audible click when it
closes.
 Are there any foreign bodies between the
door and the ring?
The foods do not heat up or they heat
very slowly:
 Did you use a metallic dish by mistake?
 Did you select the right operating time
and power level?
 Did you place a larger or colder amount
of food than usual in the microwave?
The food is too hot, dry or burned:
 Did you select the right operating time
and power level?
 The temperature in the components
compartment reached a safety limit.
Check the installation conditions.
20
front of the
contact surfaces
produce sparks if they go on fire. Therefore,
they should be cleaned on a regular basis,
but abrasive cleaning products or sharp
objects should not be used. Do not remove
the covers, to avoid any risk.
There are noises while the appliance is in
operation:
 Is there an electrical arch inside the
microwave?
 Is the dish coming into contact with the
walls of the cavity?
 Are there loose skewers or spoons inside
the microwave?
The inside lighting does not come on:
 If all of the functions are operating
correctly, the bulb is probably blown.
You may continue to use the appliance.
 The light bulb may only be replaced by
the Technical Support Service.
The power cable is damaged
 The power cable must be replaced by the
manufacturer,
technicians that are qualified to perform
this task, in order to avoid dangerous
situations and because special tools are
needed.
If any other type of fault is noticed, contact
the Customer Support Service.
All repairs must
specialised technicians.
authorised agents
be performed
or
by