Publicidad
Idiomas disponibles
Idiomas disponibles
Carpet Cleaner
5. Squeeze the solution release trigger and pull the Carpet Cleaner in a
backward motion. Release the trigger and using a steady, moderate forward
and backward motion (about 1 second per foot) push the Carpet Cleaner in
the same path to agitate and remove the dirty water and solution from the
carpet. NOTE: For heavily soiled areas repeat if necessary.
6. Work in a direction that ensures you will not walk on wet carpeting.
7. When the dirty water tank is full, lift the water tank latch and remove it from
the base using the handle. (When placing the water tank back on the base,
make sure the dirty water tank handle is clicked into place behind the white
tab.)
8. Twist the water tank outlet cap located on the bottom of the tank to the left
and remove. Then empty the tank, rinse it, and replace the cap. Replace the
tank to resume cleaning.
9. When you are finished cleaning, remove both the clean and dirty water
tanks, rinse with warm pressurized water and allow them to dry thoroughly
before replacing the tanks for storage. NOTE: When placing the dirty water
tank back into the carpet cleaner, the handle on the dirty water tank must be
pushed back and click into place behind the white tab.
10. Remove the exhaust filter on the top right side of the dirty water tank, rinse
with warm water and allow it to dry thoroughly before replacing.
AFTER CLEANING
Allow the carpet to dry thoroughly before walking on it. If you must walk on it,
place clean white towels on the carpet first. After it is thoroughly dry vacuum the
carpet.
AFTER SALES SUPPORT
888-367-7373
User Instructions
customer-service@wk-usa.com
7
Publicidad
Capítulos
