Inlet Filter - UFESA AC5000 Manual De Instrucciones

Before you start your vacuum cleaner, make sure that
the bag is fitted inside the vacuum' s compartment and
the inlet and outlet filters are fixed.
8
Start the vacuum cleaner by pressing ON/OFF
button (4).
9
Your vacuum cleaner comes with a power regulator
helping you to smoothly regulate its power. Power can
be regulated with the knob. By turning the knob clockwise
you increase the suction power or decrease it if you turn
the knob counterclockwise.
10
Your vacuum cleaner is also fitted with mechanical
suction regulator located on the hose handle. It allows
you to temporarily and slightly correct the suction power
without the need to use the knob.
Filter disassembly
Before you replace the filters, make sure the vacuum is
switched off and the plug is removed from the power outlet.

INLET FILTER

1
Turn the suction tube ending counterclockwise and
remove it from the inlet opening.
2
Release the front cover interlock (9) and open it.
3
Remove the handle with the bag from the vacuum' s
compartment.
4
Slide the inlet filter casing with the installed inlet
filter from the tracks on the back side of the vacuum
cleaner chamber.
5
Remove the inlet filter (11) from the inlet filter casing.
Place the new filter in the inlet filter casing (12) with the
material side directed towards the inside of the casing.
6
Slide the inlet filter casing (12) together with the
filter in the tracks until stop to the previous position.
7
Insert the bag with the handle into the vacuum' s
compartment. Unfold the bag inside the compartment.
8
Close the front cover of the vacuum.
Damaged inlet filter should always be
replaced with a factory new and original
item.
HEPA H13 OUTLET FILTER
1
Open the outlet filter cover by pulling the interlock.
2
Remove used outlet filter.
3
Attach new filter making sure that it is placed
correctly.
4
Close the outlet filter cover – the lid should be
locked. The click you hear confirms that the outlet filter
cover has been correctly attached.
Damaged outlet filter should always be
replaced with a factory new and original
item.
Dismantling/fitting the bag
Your vacuum cleaner is equipped with
safety valve located inside the dust
container (bag). It opens automatically,
when the suction hose or any of the elements
attached to it get choked or the dust container is
overfull. Once the valve opens, you will hear
a distinctive "whirring" sound coming out of the
machine.
C
1
When the bag filling indicator is completely covered
by the red screen when the nozzle or brush is raised
over the cleaned surface, it means that it is necessary
replace the bag. Bag filling indicator may also be triggered
if the suction hose or the elements connected to it are
clogged.
2
Switch the vacuum off by pressing ON/OFF
button (4).
● Remove the plug from the power outlet.
3
Turn the suction tube ending counterclockwise and
remove it from the inlet opening.
4
Release the front cover interlock (9) and open it.
5
Remove the handle with the bag from the vacuum' s
compartment.
6
By holding bag' s plate, pull it out of the handle (21).
7
Insert the new bag' s plate between handle' s rail
and slide it until it reaches the end of the handle. When
attaching the bag, follow the direction marked on the bag.
8
Place the handle along with the bag inside the
vacuum' s compartment. Unfold the bag inside the
compartment.
● Close the lid by pushing it until you hear the click –
D
be careful not to shut the bag.
Do not vacuum when the bag is not
attached. Without the bag inside, the
front cover of the vacuum cleaner cannot
be locked.
E