Replacing The Dust Bag; Cleaning The Motor Protection Filter; Advice On Disposal - UFESA AT9320 Instrucciones De Uso

Figure 21
- Open the cover for the appliance (see figure 15).
- Take out the dust container and insert the filter bag.
Close the vacuum cleaner cover

REPLACING THE DUST BAG

Figure 22
If the change filter indicator on the cover goes completely red
when the universal nozzle is not touching the floor and the
appliance is set to maximum suction, then it will be necessary
to change the filter bag even though it is not completely full.
Under these circumstances, the type of material being vacuu-
med requires the bag to be changed.
The nozzle, suction pipe and flexible tube must not be bloc-
ked, as this would also lead to dust bag change indicator be-
ing triggered.
• Never use the vacuum without a dust bag fitted, nor try to
empty a full bag and reuse it.
• To guarantee trouble free operation only use original Ufesa
bags, which can be found at Authorised Technical Service cen-
tres. The use of other makes of bag may damage the appliance
and make the guarantee void.
Figure 23
Open the lid by moving the locking lever in the direction of
the arrow.
Figure 24
Seal the dust bag by pulling the locking tab and then remove
it.
Figure 25
Place a new dust bag in the holder and close the vacuum clea-
ner lid.
!Caution: The dust bag compartment lid Hill only close
when the dust bag, dust collector are inserted.

Cleaning the motor protection filter

The motor protection filter should be cleaned regularly by
knocking out the dirt and rinsing.
Figure 26
– Open the dust bag compartment lid (see Figure 14).
– Pull out the motor protection filter in the direction of the
arrow.
– Clean the motor protection filter by tapping it.
– If it is very dirty, the motor protection filter should be rin-
sed.
The filter must then be left to dry for at least 24 hours.
– After cleaning, slide the motor protection filter into the va-
cuum cleaner and close the dust bag compartment lid.
CLEANING THE AIR OUTLET FILTER
Figure 27
Remove the filter cover by pressing the release catches and
jiggling it free. Remove the filter.
Important: The vacuum cleaner must never be switched on
unless this filter is fitted correctly.
To guarantee trouble-free operation, use only original Ufesa
accessories.
CARE
Always switch off the vacuum cleaner and disconnect the
power cord from the mains befote cleaning the appliance.
The vacuum cleaner and plastic accessories can be cleaned
with a commercial plastic cleaner.
!Do not use a scourer, glass-cleaning agent or multipur-
pose cleaning product.
Never immerse the vacuum cleaner in water.
If necessary, the dust compartment can be cleaned with a
second vacuum cleaner or simple wiped with a dry cloth or
dusting brush.

ADVICE ON DISPOSAL:

Our goods come in optimised packaging. This basica-
lly consists in using non-contaminating materials which
should be handed over to the local waste disposal
service as secondary raw materials.
This product complies with EU Directive 2002/96/
CE. The crossed wheelie bin symbol shown on the
appliance indicates that when it comes to dispose of
the product it must not be included in with household
refuse. It must be taken to a special refuse collection
point for electric and electronic appliances or returned to the
distributor when purchasing a similar appliance. Under current
refuse disposal regulations, users who fail to take discarded
appliances to special refuse collection points may be pena-
lised. Correct disposal of discarded appliances means that
they can be recycled and processed ecologically, helping the
environment and allowing materials used in the product to
be reused. For more information on available waste disposal
schemes contact your local refuse service or the shop where
the product was purchased. Manufacturers and importers are
responsible for ecological recycling, processing and disposal
of products, whether directly or via a public system.
Your local town council can provide you with information
about how to dispose of obsolete appliances.