Wiring Connection - JVC KD-X210 Manual De Instrucciones

Wiring connection

JVC Amplifier
Fuse (10 A)
Remote wire
(not supplied)
Ignition switch
Car fuse block
Separate
red wire
Make this connection if
your vehicle factory wiring
harness does not have
"12 V ignition switch" wire.
Signal cord (not supplied)
Rear/subwoofer
output
Antenna terminal
Join the same color wires together.
Blue/white: Remote (200 mA max.)
Orange/white: Illumination
Brown: Tel muting
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
White: Front speaker (left)
White/black
Gray: Front speaker (right)
Gray/black
Green: Rear speaker (left)
Green/black
Purple: Rear speaker (right)
Purple/black
Vehicle dashboard
Recommended
connection
Blue: To power antenna
Blue/white: To amplifier
Vehicle-specific Wiring
Harness (separately
purchased)
For more information:
Metra Electronics:
www.metraonline.com
Scosche Industries:
www.scosche.com
Part list for
installation
(A) Faceplate
(B) Trim plate
Factory wiring
harness (vehicle)
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
ENGLISH | 17