Using The Windbreak - Dometic AIR BREAK Pro 3/5 Instrucciones De Montaje

Using the windbreak

!
CAUTION! Risk of injury and
material damage
Never open the zipper on the protective
sleeve while an air pole is inflated. This
will result in the air pole bursting.
Before first use
Familiarize yourself with the product by carrying
out a test set up before the product is used for the
first time. Check if the scope of delivery is
complete.
Choosing a site
1. Choose a flat site.
2. Choose a shaded site to avoid UV degradation
of the fabric.
3. Avoid pitching under trees as falling branches,
resin, etc. can damage the product.
4. Clear the site of sharp stones and debris.
5. If used freestanding, set up the windbreak
with the opening facing away from the wind.
Setting up the windbreak
!
CAUTION! Risk of injury and
material damage
• Do not use any type of compressor
designed to inflate car tires.
• Only inflate the air poles into the green
zone of the pressure gauge of the
hand pump supplied with the main
awning (9 psi/0.62 bar).
A
NOTICE! Material damage
Do not open or close the zippers by
force.
I
NOTE
• The supplied pegs will be suitable for
many sites but for some types of
ground special pegs will be needed.
Ask your dealer.
• Drive the pegs at a 45° angle away
from the windbreak into the ground.
• Peg the guy lines in line with the seam
they start from.
Keep the following tips in mind while setting up the
windbreak:
• The illustrations provide a general overview of
the set-up. The actual set-up will vary slightly
based on the model of windbreak.
• Get help. The set-up is easier with more people.
• Peg the guy lines so that the windbreak is under
tension without distorting the shape.
• Check the guy lines from time to time to ensure
adequate tension, if necessary use the runners
to adjust.
Set up the windbreak as follows:
1. To protect the windbreak from dirt and dam-
age, lay down a groundsheet or footprint
before unpacking.
2. Unpack the windbreak.
3. Separate and identify the different
components.
4. Proceed as shown to set up the windbreak
(fig. 1, page 3 to fig. 6, page 4).
If you use the windbreak freestanding:
➤Proceed as shown to set up the windbreak
(fig. 2, page 3 to fig. 6, page 4).
Dismantling the windbreak
1. Remove all dirt from the windbreak.
2. Unpeg all pegging points and unclip all guy
lines.
3. Deflate the windbreak (fig. 7, page 5).
4. Fold/roll the windbreak towards the valves to
expel more air.
5. When deflated, roll the windbreak to fit into
the carry bag.
6. Zip and tighten the compression straps.
7. Ensure that all parts are clean before packing
them into the carry bag.
8. If the windbreak is wet or damp, dry fully as
soon as possible.
4445103328 7