Using The Window; Cleaning And Maintenance - Dometic S7P Instrucciones De Montaje Y De Uso

Using the window

9. Assemble the top mounting brackets first.
Always attach the mounting brackets from the center of the frame to the outside.
I
NOTE
If a window frame guide rail does not fit evenly against the vehicle wall,
then you must use more clips, where required, than are specified in the
table.
10. Remove the protective film from both sides of the window glass.
11. After installing, check the wall window works properly.
8 Using the window
8.1 Using S7P
Opening the window (fig. 7)
1. Proceed as follows for each rotary bolt:
Turn the rotary bolt by 90°.
2. Tilt the window pane outwards to the desired opening angle.
Closing the window (fig. 7)
1. Close the window slowly.
2. Proceed as follows for each rotary bolt:
Turn the rotary bolt by 90°.
9

Cleaning and maintenance

A
NOTICE! Damage hazard
Do not use any sharp or hard objects for cleaning since they may
damage the acrylic glass.
Only use cleaning agents that are approved by the manufacturer. Acrylic
glass polish (ref. no. 9600000128), special polishing cloth (ref. no.
9600000130) and acrylic glass cleaning agent (ref. no. 9600000129).
➤ Put talcum powder on the rubber seal.
8
S7P
EN