Publicidad
Idiomas disponibles
Idiomas disponibles
assembly
position,
terminal (A), sticking out of the column
(1) with the terminal (B) sticking out of
the platform (7).
Next, connect terminal (C), sticking
out of the column, to terminal (D),
sticking out of the platform (7). Once
all
of
the
terminals
connected, push them inside the
column (1) to protect them and fit the
column (1) on the platform, lining up
the bolt holes.
Take the transportation wheel (40)
support along with the safety washers
(26) and the flat washers (25), and
tighten securely using the 8mm Allen
key.
For the next stage of the assembly it is
advisable to place the platform back
on the floor with the help of a second
person.
Take the handlebar (4) as position it
as shown in Fig.3, lining up the holes.
Fit the screws (29) and flat washers
(6) and use the 6mm Allen key to
tighten them securely.
It is possible that the hand straps may
have come loose during shipment. Fit
them back as shown in Fig.4.
START-UP.-
1 Plug the mains cable (35) into the
socket (M) on the column, Fig.5.
The other end of the cable is plugged
into the electric wall socket (220V).
Set switch (L) to position (I), Fig.5.
Note: A mechanical knocking noise is
normal when the vibration motors first
begin to turn, this will stop as soon as
the motors reach working speed.
Similarly, when the motor is switched
off you will also hear this knocking
Fig.2,
connect
have
been
noise as the motor slows down, but it
will stop as soon as the motor is at a
standstill.
MOVEMENT & STORAGE.
The unit is equipped with wheels (40),
Fig.6, to make it easier to move.
Make sure that the mains cable is
unplugged from the wall socket.
To prevent accidents DO NOT move
the platform across uneven floors.
INSPECTION & MAINTENANCE
Switch the unit off and unplug the
mains cable.
Use a damp cloth or towel to clean the
dust off the platform, especially the
handrails and the electronic console.
Do not use solvents.
ATTENTION:
Periodically check that all of the
fastening
tightened and connected correctly.
Check and tighten all the parts on
your unit every three months.
When in doubt about any parts on the
machine, do not hesitate to get in touch
with the Technical Assistance Service
by phoning customer services (see last
page in manual).
We recommend that your use original
spare parts to replace any worn
components. The use of other spare
parts may cause injuries or affect the
performance of the machine.
THE MANUFACTURER KEEPS THE
RIGHT TO MODIFY THE PRODUCT
SPECIFICATIONS
PREVIOUS ADVISE
12
elements
are
WITH
.
duly
NO
Publicidad
