Inspection & Maintenance - BH FITNESS YV56 Instrucciones De Montaje Y Utilización

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
The assistance of a second person is
recommended when assembling this
platform. Position the platform as
shown in Fig.2, lifting and resting the
four feet on a table, for example.
1.- At least two people are needed for
this step. When fitting the column, one
person should hold the column while
the other one follows the assembly
instructions. This will prevent any
possible accidents.
First take the column (17) and put it
into assembly position, Fig.2, connect
terminal (5), sticking out of the column
(17) with the terminal (6) sticking out
of the platform (37).
Next, connect terminal (18), sticking
out of the column (17), to terminal
(10), sticking out of the platform (37).
Once all of the terminals have been
connected, push them inside the
column (17) to protect them and fit the
column (17) on the platform, lining up
the bolt holes.
Fit
Self-locking
washers (22) and flat washers (23)
and use the key to tighten them
securely.
Lower the bottom trim section (19)for
the main post (10) down over the boss
section of the main body (37), fit the
screws (46), and tighten securely
Fig.2.
For the next stage of the assembly it is
advisable to place the platform back
on the floor with the help of a second
person.
2.- Take the vibration head (11) and
position it onto the plate of the column
(17) Fig.3.
Connect terminal (2) coming out of the
vibration head with terminal (3) coming
out of the column (17), connect terminal
nuts
(21),
safety
(13) coming out of the vibration head
with terminal (18) coming out of the
column (17).
Now fit bolt (12), along with the safety
washer (8), washers (9) and tighten
securely.
3.- Take the handlebar (4), and slot it
into position as shown in Fig.4 by
lining up the holes.
Fit the screws (7) safety washer (8)
and flat washers (9) and use the 6mm
Allen key to tighten them securely.
Now fit bolt (6), washers (5) and
tighten securely.
4.- Fit the hand straps (24) onto the
platform's outer rings (37) as shown in
Fig.5.
5.- Take one of the massage bands
and fit it as shown in Fig.6.
First fit the end of the band into the
eccentric and then lower it so that it is
inserted properly.
START-UP.-
Plug the mains cable (14) into the
socket (M) on the column, Fig.7.
The other end of the cable is plugged
into the electric wall socket (220V).
Set switch (L) to position (I), Fig.7.
MOVEMENT & STORAGE.
The unit is equipped with wheels (45),
Fig.7, to make it easier to move.
Make sure that the mains cable is
unplugged from the wall socket.
To prevent accidents DO NOT move
the platform across uneven floors.
INSPECTION & MAINTENANCE
Switch the unit off and unplug the
mains cable.
Use a damp cloth or towel to clean the
dust off the platform, especially the
handrails and the electronic console.
12

Publicidad

Tabla de contenido
loading

Tabla de contenido