Best WTD9M Serie Instrucciones De Instalación página 4

3. REMOVE THE GREASE FILTERS
Rest the range hood on a protected surface and remove the tape from the filters. Remove the filters from the range hood by pushing them
towards the nose of the hood and rotate downwards. Remove the parts bag, the adapter ring and the hood mounting bracket from inside
the hood and set these parts aside.
HD1079
4. REMOVE THE WIRING COVER AND THE BLOWER PLATE
Using a Philips no. 2 screwdriver, remove the 3 retaining
screws (circled in illustration below) holding the wiring
cover inside the hood. Set aside the cover and its screws.
HD1085
5. INSTALL THE ADAPTER AND THE WIRE CLAMP
Install the 10-inch round adapter on the top of the hood using 2 no. 8-18 x 3/8" Phillips screws.
NOTE: Use the smaller notches around the adapter.
Install the wire clamp (as shown in the inset on illustration at right).
Using a 3/8" nutdriver, remove 2 nuts retaining the blower
plate to the inner top of the hood, set the plate and nuts
aside.
HD1086
4
HJ0186