Residual Water In The Oven; Safety Instructions; Safety Block; Descale - Teka HLC 847 SC Guía De Uso

Ocultar thumbs Ver también para HLC 847 SC:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Residual water in the oven

To reduce the residual water in the oven, it is
recommended to insert a tray in the bottom
rack level. The condensation released from
the food begins to drip on the tray. The

SAFETY BLOCK

This function can be selected at any time
while using the oven.
 With the oven switched off. The child lock
will not allow the oven to be switched on
when the
button is touched.
 With the oven in use. If the feature is
activated while the oven is cooking or set to
delay, the keypad will not respond and it
will not be possible to use the dials or
change the cooking settings.

DESCALING PROCEDURE

1. Rotate the left dial to enter the Steam
menu.
2. Rotate the right dial until the Descaling
symbol
appears on the right side of
the display.
3. Press the
function.
4.
water tank.
5. Pour 0.5 liters of an adequate descaling
solution into the water tank and put the
water tank back.
6. Press
. The Descale cycle is initiated
and takes about 30 minutes.
to start the descaling
0,5 remove the
remaining residual water can be easily dried
with a cloth. Take care the drip tray under the
door is dried after every use. A build-up of
liquid in this tray can quickly overflow and
damage the surrounding cupboards. It is
accessed through the opened door.
To activate this feature press and hold the
and
buttons simultaneously until you
hear a beep and the
the screen. The control panel is now locked.
To deactivate this feature touch and hold
the
and
buttons simultaneously again
until you hear a beep and the
disappears.
8. The descaling process is silent and during
this process, the display shows the
percentage of the process and the
descaling symbol
9. When the display shows
emits a beep, remove and empty the
water tank.
10. Fill the water tank with 0,5 liters of fresh
water and put the water tank back.
11. Close the panel The first rinsing cycle
starts.
12. When the display shows again
the oven emits a new beep, remove and
empty the water tank.
13. Fill the water tank with 0.5l of cold water
and put the water tank back.
EN
symbol appears on
symbol
.
and the oven
and
17

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido