Symbols On The Product - Husqvarna 324L Manual Del Usuario

1. Trimmer head
2. Bevel gear
3. Grease filler cap
4. Cutting attachment guard
5. Shaft
6. Loop Handle
7. Stop switch
8. Throttle trigger
9. Throttle trigger lockout
10. Cylinder cover
11. Starter rope handle
12. Air purge bulb
13. Fuel tank
14. Choke control
15. Air filter cover
16. Handle adjustment
17. Drive disc
18. Hex key
19. Locking pin
20. Operator's manual
21. Oil
22. Combination wrench
23. Wrench

Symbols on the product

Be careful and use the product correctly.
This product can cause serious injury or
death to the operator or others.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection. Use approved eye
protection.
Use approved protective gloves.
Use heavy-duty slip-resistant boots.
The product can cause objects to eject,
which can cause injury.
1323 - 002 -
Maximum speed of the output shaft.
Keep a minimum of 15 m distance to
persons and animals during operation of the
product.
Only use flexible cutting wire. Do not use
metal cutting equipment for grass trimming.
The arrows show the limit for the handle
position.
Air purge bulb.
Choke.
Fuel.
yyyywwxxxx
Note: Other symbols/decals on the product refer to
certification requirements for some markets.
EPA III
The Emissions Compliance Period referred to on the
Emission Compliance label indicates the number of
operating hours for which the engine has been shown to
meet Federal and California emissions requirements.
The rating plate shows the
serial number. yyyy is the
production year, ww is the
production week.
3