Sony SU-WL11 Instrucciones página 7

Step 3:
Attach bracket A to
the wall
Insert four M4×20 mm (
1
inches) screws (or screws of an
equivalent size) that are
adequate for the wall at the
positions marked in Step 2 (page
6). Never use the supplied
screws to fix the bracket to the
wall.
Do not tighten the screws completely
for the moment. Keep a space of 2 to 3
3 1
mm ( / to /
32 8
Screws you
provided
Press bracket A to the wall and
2
slide it down. Then fully tighten
the four screws on the wall.
Bracket A
top
Wall
bottom
Insert four M4×20 mm (
3
inches) screws (or screws of an
equivalent size) that are
adequate for the wall in the
screw holes, and tighten them
securely in the order of 1 to 4
as shown below. Never use the
supplied screws to fix the
bracket to the wall.
1
Screws you
provided
4
13 /
16
inches) from the wall.
13
20 mm ( / inches)
16
Wall
3 1
2 to 3 mm ( / to
32
inches)
,
Bracket A
13 /
16
3
Bracket A
2
Step 4:
Remove the tabletop
stand from the TV
Be sure to refer to the Leaflet (Installing
the Wall-Mount Bracket to the TV)
supplied with the TV.
If the TV has a rear cover, remove it
before removing the tabletop stand.
Also disconnect all the cables from the TV
before removing the tabletop stand.
For details regarding how to remove the
rear cover and disconnect all the cables
from the TV, refer to the Operating
Instructions supplied with the TV.
Remove the screws as shown
1
below, then remove the
tabletop stand from the TV.
/
8
To prevent damaging the surface of the
display, place the TV on a soft mat.
Soft mat
Rear of the TV
Notes
• Lay the display face down on a
stable and level surface with the
tabletop stand hanging over the edge
of the surface. Having the display
face and the base of the stand on the
same level surface will create an
unstable working condition and can
damage the unit.
• Hold the tabletop stand firmly while
removing.
Remove the screws.
Tabletop stand
US
7