Safety Instructions For Maintenance; To Remove The Product From The Carton; Loose Parts; Assembly - Husqvarna ST 224 Manual Del Usuario

• Do not add fuel to the engine in an indoor area.
Not sufficient airflow can cause injury or death
because of asphyxiation or carbon monoxide.
• Tighten the fuel tank cap fully. If the fuel tank cap
is not tightened, there is a risk of fire.
Proposition 65

Safety instructions for maintenance

WARNING: Read the warning
instructions that follow before you use
the product.
• The exhaust fumes from the engine contain
carbon monoxide, an odorless, poisonous and
very dangerous gas. Do not start the engine
indoors or in closed spaces.
• Before you do the maintenance on the product,
stop the engine and remove the ignition cable
from the spark plug.
• Use protective gloves when you do maintenance
on the blades. The blades are very sharp and
cuts can easily occur.
To remove the product from the
carton
1. Remove loose parts included with the product.
Cut the four corners of the carton and put the
end panels down flat.
2. Remove the two screws that attach the auger
housing to the pallet. Remove the steel brackets
from the skid plates if they have it.
3. Remove all package materials.
4. Remove the product from the carton and make
sure no loose parts are left in the carton.

Loose parts

Knob (3)
8
WARNING
The engine exhaust from this product
contains chemicals known to the State of
California to cause cancer, birth defects
or other reproductive harm.

Assembly

• Move the product a minimum of 3 m (10 ft) from
the position where you filled the tank before a
start.
• Do not put too much fuel in the fuel tank.
• Accessories and changes to the product that are
not approved by the manufacturer, can cause
serious injury or death. Do not change the
product. Always use accessories that are
approved by the manufacturer.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Only do the maintenance as given in this
operator's manual. All other servicing must be
done by an approved service agent.
• Let an approved service agent do servicing on
the product regularly.
• Replace damaged, worn or broken parts.
Discharge chute (1)
ON/OFF key (s)
Carriage bolts 5/16-18 x 2 ¼" (2)
Handle knobs (2)
694 - 003 - 07.11.2019