HOLZMANN MASCHINEN DKS 21PRO Manual De Instrucciones página 27

1
Work lamp:
On: I
Off: 0
Dust collector
plug:
Operate only with
connected dust
collector
Dust blower:
Set the dust blower nozzle so, that the cutting
line will always be free of dust and will be seen
very well.
Saw blade guard:
Set the saw blade guard as
near as possible to the
workpiece.
Inside cut:
This saw is suited also to inside cuts not starting at the edge of the work piece.
Proceed as follows:
• Drill a 6 mm hole in the workpiece
• Remove the saw blade.
• Place the bore hole over the saw blade slot in the worktable.
• Install the saw blade through the hole in the work piece and through the work blade slot, and
fasten the blade to the holders.
• When you have completed the inside cut, remove the saw blade and then remove the workpiece
from the work table.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
PREFACIO
Página 27
DKS 21PRO