Filling With Oil; Assembling And Dismantling The Two-Piece Shaft; Fitting The Impact Guard - Husqvarna 327P4 X-serie Manual De Instrucciones

Filling with oil

• Open the cap on top of the bar head
• Fill with Husqvarna saw chain oil.
• Refit the cap.
Assembling and dismantling the
two-piece shaft
(327P5)
Assembly:
• Loosen the coupling by turning the knob.
• Align the tab of the attachment (A) with the arrow on
the coupling (B).
B
• Push the attachment into the coupling until the
attachment snaps into place.
16 – English
ASSEMBLY
A
• Before using the unit, tighten the knob securely.
Dismantling:
Loosen the coupling by turning the knob (at least 3 times).
• Push and hold the button (C). While securely holding
the engine end, pull the attachment straight out of the
coupling.
C

Fitting the impact guard

(327P5)
If the machine has a impact guard bolted under the
engine this should be removed before the impact guard is
assembled.
Fit the guard using the three screws and washers. Fit the
two short screws in hole A. Tighten the screws to a torque
1156923-49 Rev. 3 2014-12-02