To Fill With Oil; Operation; To Check Before Starting; To Use The Product - Husqvarna PS-EX1100 Manual Del Usuario

3. Adjust the length of the harness until the support
hook is roughly level with your right hip.

To check before starting

1. Inspect the working area. Remove any objects that
could be thrown out.
2. Check the saw chain. Never use blunt, cracked or
damaged equipment.
3. Check that the product is in perfect working order.
4. Check that all nuts and screws are tight.
5. Make sure the chain is adequately lubricated, refer
To lubricate cutting equipment on page 13 .
to
6. Check that the saw chain always stops when the
engine is idling.
7. Only use the product for the purpose it was intended
for.
8. Make sure the handle and safety features are in
order. Never use a machine that has any parts
missing or has been modified in relation to the
specification.

To use the product

• Hold the product as close to your body as possible to
get the best balance.
• Make sure that the tip does not touch the ground.
• Do not rush the work, but work steadily until all the
branches have been cut back cleanly.
• Always slow the engine to idle speed after each
working operation. Long periods at full throttle
without any load on the engine can lead to serious
engine damage.
• Always work at full throttle.
WARNING: Observe the applicable
safety regulations for work in the vicinity
of overhead power lines.
• Observe great care when working close to overhead
power lines. Falling branches can result in short-
circuiting.
443 - 004 - 24.08.2018

To fill with oil

1. Open the oil cap on top of the bar head.
2. Fill with saw chain oil.
3. Attach the cap again.

Operation

WARNING: Never stand directly
underneath a branch that is being cut.
This could lead to serious or even fatal
personal injury.
WARNING: This product is not
electrically insulated. If the product
touches or comes close to high-voltage
power lines it could lead to death or
serious bodily injury. Electricity can jump
from one point to another by arcing. The
higher the voltage, the greater the
distance electricity can jump. Electricity
can also travel through branches and
other objects, especially if they are wet.
Always keep a distance of at least 10 m
between the product and high-voltage
power lines and/or any objects that are
touching them. If have to work within this
safe distance you should always contact
the relevant power company to make
sure the power is switched off before you
start work.
WARNING: This product has a long
reach. Make sure that no people or
animals come closer than 15 m when the
product is running.
7