To Fill The Fuel Tank; To Prepare The Product For Start; To Use The Correct Chain Oil; To Start The Product - Husqvarna 525DEPS Manual Del Usuario

5. Carefully shake the fuel mixture.
CAUTION: Do not mix fuel for more than 1
month at a time.

To fill the fuel tank

1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel is
fully mixed. Use a fuel container with an anti-spill
valve.
3. Fill the fuel tank.
4. Tighten the fuel tank cap carefully.
5. Move the product 3 m (10 ft) or more away from the
refueling area and fuel source before starting.
CAUTION: Contamination in the tanks
causes malfunction. Clean the fuel tank and
chain oil tank regularly and replace the fuel
filter one time a year or more.

To use the correct chain oil

WARNING: Do not use waste oil, which can
cause injury to you and the environment.
Waste oil also causes damage to the oil
pump, the guide bar and the saw chain.
WARNING: The saw chain can break if the
lubrication of the cutting equipment is not
sufficient. Risk of serious injury or death to
the operator.
WARNING: This product has a function that
lets the fuel run out before the chain oil. Use
the correct chain oil for this safety function to
operate correctly. Speak to your servicing
dealer when you select your chain oil.
Note: This product has an automatic chain lubrication
system. You can also adjust the oil flow. Refer to
adjust chain lubrication on page 24 .
• Use only Husqvarna dielectric chain oil.
14
• Use the recommended cutting equipment. Refer to
Recommended cutting equipment on page 26 .

To prepare the product for start

1. Push the air purge bulb 10 times.
Note: It is not necessary to fully fill the bulb.
2. Move the choke control up into choke position.

To start the product

1. Use protective gloves.
2. Hold the body of the product on the ground with your
left hand.
To
3. Hold the starter rope handle with your right hand.
CAUTION: If the oil is too thin, it runs out
before the fuel. In temperatures below
0°C/32°F some chain oils become too
thick, which can cause damage to the oil
pump components.
WARNING: The saw chain will start to
rotate immediately when you start the
engine with the choke.
WARNING: Read the warning instructions in
the safety chapter before you start the
Safety on page 4 ).
product (refer to
CAUTION: Do not use your feet!
1480 - 003 - 05.08.2020