Assembly; Trimmer Guard; Fitting The Trimmer Head; Fitting The Loop Handle - Husqvarna 115iL Manual De Instrucciones

Trimmer guard

• Slide the trimmer guard into the trimmer head.
(Figure 34)
• Fasten the trimmer guard onto the housing to the
trimmerhead. (Figure 35)

Fitting the trimmer head

• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin into the hole to lock the axle.
• Screw on the trimmer head in the opposite direction to
the direction of rotation.
• To dismantle, follow the instructions in the reverse
order. (Figure 33)

Fitting the loop handle

• Fit the screw into the loop handle.
• Slide the loop handle into the fitting on the shaft.
• Tighten the screw that secures the loop handle.
(Figure 36)
• Now adjust the trimmer to give a comfortable working
position. (Figure 11)
Adjust the length of the trimmer
cord
• Make sure that the cutter on the trimmer guard is
intact. This is used to cut the cord to the correct length.
• When using trimmer head, make sure the trimmer line
have correct length and is cut by the guard knif.
• Adjust the length of the trimmer cord by moving the
cutter on the trimmer guard. The cutter has two
different adjustment positions on the trimmer guard.
(Figure 37)
12 – English

ASSEMBLY