Conceptronic CPNP200P Manual De Instrucciones página 5

Nr Description
A. „Pair‟ button
With the „Pair‟ button, you can create a secured Powerline network.
B. „AP‟ LED
The „AP‟ LED indicates if a Powerline adapter is configured as main Access Point
(AP) adapter, or if a network setup is in progress.
C. „P-Link‟ LED
The „P-Link‟ LED indicates if a Powerline network is established and shows the
signal quality.
D. „E-Link‟ LED
The „E-Link‟ LED indicates if the LAN port is in use.
LED Status
AP Off
On - Steady
On – Flashing
P-Link Off
On - Red
On - Green
On - Flashing
E-Link Off
On – Green
On - Flashing
2. Device explanation
Explanation
The Powerline adapter is not set as Access Point.
The Powerline adapter is set as Access Point.
The Powerline adapter is accepting connections for a secured
Powerline network.
The Powerline adapter is in Standby mode.
No Powerline network or bad Powerline signal quality.
A Powerline network is active with good signal quality.
Data is send /received through the Powerline network.
No LAN connection.
The LAN connection is active.
Data is send / received through the LAN connection.
ENGLISH
5