Backlight - SILVER CREST SRH 5 C3 Instrucciones De Uso E Indicaciones De Seguridad

Backlight

Timeout
You can use the Timeout function to set the number of seconds after which the
display backlight is dimmed after the device is switched off or after a button was
pressed.
While in the System menu, press the TUNE+
♦
times if necessary) or turn the VOLUME |
until Backlight appears on the display
Press the VOLUME |
♦
Press the TUNE+
♦
VOLUME |
the display
Press the VOLUME |
♦
Press the TUNE+
♦
VOLUME |
out], 10, 20, 30, 45, 60, 90, 120, 180 seconds).
Press the VOLUME |
♦
On level
The On level function allows you to adjust the brightness level of the display
backlight during operation.
While in the System menu, press the TUNE+
♦
times if necessary) or turn the VOLUME |
until Backlight appears on the display
Press the VOLUME |
♦
Press the TUNE+
♦
VOLUME |
on the display
Press the VOLUME |
♦
Press the TUNE+
♦
VOLUME |
of the display backlight (low, medium, high).
Press the VOLUME |
♦
■ 34 GB │ IE
│
ENTER / SCAN dial
8 7
or TUNE−
ENTER / SCAN dial
1
.
ENTER / SCAN dial
8 7
or TUNE−
ENTER / SCAN dial
ENTER / SCAN dial
ENTER / SCAN dial
8 7
or TUNE−
ENTER / SCAN dial
1
.
ENTER / SCAN dial
8 7
or TUNE−
ENTER / SCAN dial
ENTER / SCAN dial
8
or TUNE−
ENTER / SCAN dial
1
.
6
to confirm the selection.
button several times or turn the
6
until Timeout appears on
6
to confirm the selection.
button several times or turn the
6
to select the time (On [no time-
6
to confirm the selection.
8
or TUNE−
ENTER / SCAN dial
1
.
6
to confirm the selection.
button several times or turn the
6
until On level appears
6
to confirm the selection.
button several times or turn the
6
to select the brightness level
6
to confirm the selection.
7
button (several
6
7
button (several
6
SRH 5 C3