Switching On And Off - STERWINS EGT2-28.3 Manual De Instrucciones

2. SAFETY INSTRUCTIONS
Trimming
Before use, check that the trimmer in good working order ,as follows:
1. Ensure the switch is on the off position and disconnect the cable plug
from the mains supply.
2. Examine the general condition of the tool. Inspect the guard and
switch. Check for loose screws, misalignment, and binding of moving
parts, improper mounting, broken parts and any other condition that
may affect its safe operation. If abnormal noise or vibration occurs
during operation, turn machine off immediately and have the problem
corrected .Do not use a damaged tool and attach a label "DO NOT USE" to
the tool.
3. Ensure that you are on a flat surface and have secure footing.

Switching on and off

Connect the cable to the power.
To switch on, keep the switch trigger depressed.
To switch off, release the switch trigger.
WARNING! The tool runs for approximately 5 seconds after it has been
switched off. Let the motor came to a complete stand still before setting
the tool down.
EN
246