Replace The Blades; To Replace The Blades; Troubleshooting - Husqvarna AUTOMOWER 105 Manual Del Usuario

5.3 Replace the blades

WARNING: Always use blades and
screws of the right type. Husqvarna
can only guarantee safety when using
original blades. Only replacing the
blades and reusing the screw can
result in a screw wearing during
mowing and shearing. The blades can
then be propelled from under the body
and cause serious injury.
Replace worn or damaged parts for safety
reasons. Even if the blades are intact, they
should be replaced on a regular basis for the best
mowing result and low energy usage.
All 3 blades and screws must be replaced at the
same time to obtain a balanced cutting system.
Use Husqvarna original blades embossed with
the crowned H-mark logotype, refer to
terms on page 26 .

6.1 Troubleshooting

In case of malfunction, a message will appear on the display. For more detailed information on
messages, refer to the complete Operator's manual on Husqvarna's website (www.husqvarna.com. If
the same message appears often or if you still cannot find the reason for the fault, contact your dealer.
Breaks in the loop wire are usually the result of unintentional physical damage to the wire such as
when gardening with a shovel. Breaks can also be due to the wire being stretched excessively during
installation. A wire break can be located by gradually halving the distance of the loop where the break
may have occurred, until there is only a very short section of the wire left. Refer to the complete
Operator's manual on Husqvarna's website (
903 - 001 - 21.09.2018

5.3.1 To replace the blades

1.
2.
3.
4.
5.
6.
Guarantee
7.
6 Troubleshooting
www.husqvarna.com ).
Set the main switch to position
Turn the product upside down. Place the
product on a soft and clean surface to avoid
scratching the body and the hatch.
Rotate the skid plate so that its holes align
with the screws for the blade.
Remove the 3 screws. Use a straight slot or
cross-tip screwdriver.
Remove each blade and screw.
Fasten new blades and screws.
Check that the blades can pivot freely.
0 .
Troubleshooting - 19