Belt Replacement; Replacing Belt; Replacing Brush Roll - SSS AF6 Instrucciones De Operación

3-13
Reposition door
Place tabs (B) on door into slot in lower
front of cleaner. Close door.
Should you want to replace this filter, ask
for part No. 38766017.
3-15
Removing used belt
Remove agitator brush roll and used
belt.
Discard used belt.
3-18
E
Installing brush roll
Grasp brush roll firmly and fit it into posi-
tion by first sliding end opposite the belt
into the rectangular slot (E) on side of
cleaner.
Pull other side of brush roll (F) into
place.
Turn brush roll making sure belt is not
pinched between brush roll and cleaner
base.
10

Belt replacement

B
The belt on your cleaner causes the agi-
tator to rotate and is important for the
effective operation of the cleaner. The
belt is located under the bottom plate of
the cleaner and should be checked from
time to time to be sure it is in good con-
dition.
When to replace
To check belt, remove bottom plate as
shown in "How to replace." Replace
belt if it is stretched, cut or broken.
What to buy
To assure effective operation, use only
genuine Triple S belts with your
cleaner. When purchasing a new belt,
ask for part No. 38528040.
3-16
C
B
Positioning belt over pulley
With lettering on outside of belt and
positioned as shown in box on (C), slide
new belt over motor pulley (B).
3-19
F
Replacing bottom plate
Reposition bottom plate and 4 Phillips
head screws. Tighten screws securely.
3-14
A
How to replace
Removing bottom plate
Disconnect cleaner from electrical
outlet.
Place handle in low position and turn
cleaner over.
Remove the 4 screws as shown with a
Phillips screw driver.
Lift off bottom plate (A).
3-17
Positioning belt over brush
roll
Insert brush roll through belt and place
belt in belt guide (D) on brush roll.
Agitator brush roll
replacement
3-20
When to replace
Disconnect cleaner from electrical
outlet.
When brush roll brushes are worn, it
should be replaced.
To check condition of brushes, move
edge of a card across bottom plate
while turning brush roll. To maintain
cleaning effectiveness, replace brush roll
if brushes do not touch card.
D