SSS AF6 Instrucciones De Operación página 3

Step 2 Attach cord
1-3
E
With side marked "UP" visible, insert
large rectangular end of cord into
pocket in bottom of handle.
Make sure rectangular end is
pushed down into the handle as far
as possible.
Slide cord protector (E) toward
upper handle.
1-6
Press cord into place at each of the
three notches indicated.
Do not plug cleaner in until
assembly is totally complete.
Make sure cord is on the side of rod
(B).
1-9
K
Pull bracket toward bottom of handle
slightly to make sure bracket is
locked in place.
Make sure hole in bracket aligns
with hole in handle (K).
1-4
Rotate cord protec-
tor (E) as shown
(toward back of
handle).
Step 3 Attach handle
B
1-7
I
Note location of tapered rails (H) on
bracket (I) and on lower handle.
1-10
With ON/OFF switch to the front,
place assembled handle down onto
extension on cleaner base.
Rock handle side to side while
pushing down firmly. Extra pushing
effort may be required.
Push bolt into hole (L) on lower front
of handle.
If bolt will not go through hole
easily , check the following:
• the bracket is properly
positioned (Fig. 1-9)
• the handle is pushed down
completely (Fig. 1-10)
1-5
E
F
With (E) pointing downward, press groove (F) into slot
(G).
Pull cord tight.
H
L
E
G
1-8
I
J
With printed side of bracket (I)
facing up, slide rails on bracket
onto rails (H) on lower handle until
bracket snaps past the lock tab (J).
1-11
M
Place nut in recessed area (M) at
back of handle. Hold nut in place
while tightening bolt securely with a
screw driver.
Only one nut is needed on this
model. The extra nut is not required
but has been provided for your
convenience.
H
3