Berner BBS-100 Instrucciones De Servicio página 9

English
PRECAUTIONS ON USING BELT SANDER
CAUTION
Prior to the sanding operation, make sure the
material you are going to sand.
If generation of harmful/ toxic dusts such as lead
paint, woods and metals is expected under the
SPECIFICATIONS
Voltage (by areas)*
Power input*
No–load belt speed
Sanding belt size
Weight (without cord)
* Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Endless sanding belt (Grain size: #80) ................ 1
(2) Dust bag .................................................................... 1
Standard accessories are subject to change without
notice.
APPLICATIONS
Finish sanding and finish flooring of woodwork
products.
Base polishing of wood-coated surfaces.
Finish sanding of metal surfaces.
Base polishing of metal-coated surfaces, rust
removal, or paint removal prior to refinishing.
Surface finishing of slate, concrete, and similar
materials.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
an rated capacity. The extension cord should be
kept as short as practicable.
4. Attach the sanding belt
For details, refer to the section on "Sanding Belt
Assembly".
8
sanding operation, make sure the dust bag or
appropriate dust extraction system is connected
with dust outlet tightly.
Wear the dust mask additionally, if available.
Do not inhale or touch the harmful / toxic dusts
generated in sanding operation, the dust can
endanger the health of yourself and bystanders.
(110V, 120V, 127V, 220V, 230V, 240V)
1020 W
420 m / min
100 × 610 mm
5.2 kg
HOW TO HANDLE SANDING BELT
CAUTION:
Be sure to switch power OFF and disconnect the
plug from the receptacle to avoid serious trouble.
1. How to attach sanding belt
(1) Pull lever with finger, idle pulley will then move
backward. (Fig. 1)
(2) Place on drive pulley and idle pulley passing it over
the outside of shoe plate and making sure that
arrow on inside of belt coincides with rotational
direction of drive pulley. (Fig. 2)
(3) Push lever with finger, idle pulley will then move
forward and give proper tension to sanding belt.
In this case, be careful not to be hit your finger
by lever.
Then, adjust sanding belt position.
CAUTION:
Sanding belt installed in the wrong direction will
lower work efficiency and shorten life of sanding
belt.
2. How to remove sanding belt
Pull lever with finger, sanding belt will then sag and
can be taken off pulleys eqsily.
DUST REMOVAL
When an excessive amount of dust is deposited in the
dust bag, dust-collecting efficiency will sharply drop.
Remove dust from the bag when it is deposited up to
about 2/3 the bag capacity, where by dust collecting
efficiency (as well as working efficiency) will be ensured.
Remove dust from the bag as follows:
(1) Loosen the support bar and remove the dust bag.
(Fig. 5)
(2) The bag inlet can be opened by unzipping the slide
fastener.