Complete The Installation - Kohler K-175 Guia De Instalacion

Connect the Components (cont.)
All Connections
Reinstall the access covers. Do not overtighten.
Plug the power cord into the outlet, or for hard-wire options, turn on the power. Verify that the
indicator light turns on and pulses.
Test each component to ensure proper functionality. Refer to the Installation and Homeowner
Guides packed with each of the individual components for additional information.

6. Complete the Installation

Reinstall the access covers. Do not overtighten.
If not already installed, install any additional components at this time according to the installation
instructions packed with the products. For connecting to the media module, refer to the "Connect
the Components" section.
Plug the power supply into the outlet. Verify that the indicator light turns on and pulses.
Configure your music server and Ethernet. Refer to the Media Module Homeowner's guide.
7. Installation Checkout
Test each component to ensure proper functionality. Refer to the Installation and Homeowners
Guides packed with each of the individual components for additional information.
Troubleshooting
CAUTION: Risk of personal injury. The valve (if installed) may contain hot water; be careful when
draining any residual water.
IMPORTANT! Turn off the power and water supply to all components before performing any
maintenance.
It is recommended that any valve maintenance should be performed by a Kohler Co. Authorized Service
Representative.
This troubleshooting guide is for general aid only. For service and installation issues or concerns, call
1-800-4-KOHLER.
Interface Troubleshooting Table
Symptoms
1. Digital interface is not lit.
1093174-2-C
Probable Cause
A. Media module is not plugged
into the outlet.
B. Power supply connection to the
media module may be loose or
disconnected.
C. Interface cable connections may
be loose or disconnected.
D. Circuit breaker has been
tripped.
E. The media module may require
resetting.
F. If none of the recommended
actions for the above issues
correct the symptom, the media
module or interface requires
servicing.
Recommended Action
A. Plug the media module into the
outlet.
B. Check power supply connections to
the media module and reconnect if
needed.
C. Check all interface cable
connections, connect if needed.
D. Reset the circuit breaker.
E. Disconnect and reconnect the
power supply from the media
module.
F. Contact your Kohler Co.
Authorized Service Representative.
12 Kohler Co.