Prepare The Site - Kohler K-175 Guia De Instalacion

20-1/2"
(52.1 cm)

2. Prepare the Site

CAUTION: Risk of product damage. The media module is rated to operate in temperatures up to
104°F (40°C). Do not install in any location where the temperature may exceed 104°F (40°C).
The media module is designed to fit within a 13" (33 cm) to 19" (48.3 cm) wide 2x4 stud cavity. The
cavity should be free of cross bracing and insulation.
Brackets should be positioned 20-1/2" (52.1 cm) apart. Allow enough room to one side of the media
module to accommodate the electrical outlet installation and power cord connection.
Measure 2-5/8" (6.7 cm) to 2-7/8" (7.3 cm) in from the stud face to determine the bracket placement.
Mark the bracket locations with a pencil.
Install a 15 A 120 V GFCI electrical outlet within the stud framing, in close proximity to the media
module.
If used, run the Ethernet cable to the media module installation site.
Kohler Co.
Outlet
2-5/8" (6.7 cm) to
2-7/8" (7.3 cm)
Pencil
13" (33 cm) to
19" (48.3 cm)
7
Drip Loop
Media Module
(not installed)
1093174-2-C