ALWAYS FOLLOW ALL SAFETY PRECAUTIONS AND
RECOMMENDATIONS LISTED PREVIOUSLY IN THIS
MANUAL.
1. Power off the reel mower and remove the battery and the
safety key.
2. To adjust the cutting height, pull out the height adjustment
knobs on both sides of the reel mower frame and insert
the knobs to the desired setting (Fig. 13).
Fig. 13
Height adjustment
knob (on both sides)
3. To adjust the reel to the highest cutting position, place the
adjustment knobs through the top hole (position A) located
on the sides of the reel mower frame. To adjust the reel to
the lowest cutting position, place the adjustment knobs
through the bottom hole (position B) located on the sides
of the frame (Fig. 14).
Fig. 14
Highest cutting position
Position A
4. Other cutting heights are achieved by moving the
adjustment knobs to the settings between the highest
and lowest positions. Refer to the mark beside the height
adjustment knobs when adjusting the cutting height
(Fig. 15).
4-Position Height Adjustment:
(1) Low: 0.6 in. (15 mm)
(2) Medium: 1.0 in. (28 mm)
(3) Medium: 1.5 in. (39 mm)
(4) High:2.0 in. (50 mm)
The cutting height tolerance is +/- 0.12 in. (3 mm).
Lowest cutting position
Position B
Fig. 15
Cutting height mark
Starting + Stopping
m
WARNING!
Before switching on the reel mower, make
sure that it is not in contact with any foreign objects. Keep your
hands and feet a safe distance away from the rotating mower
blades and the ejector opening. Failure to comply with these
warnings can result in severe personal injury.
IMPORTANT: Do not start the reel mower in tall grass.
1. Make sure the unit's On/Off switch lever is not squeezed
on. Insert the battery and the safety key in their slots
(Fig. 16). Close the battery compartment cover.
Fig. 16
Battery
pack
2. To start the machine, press and hold the safety lock
button, then pull the On/Off switch lever toward you (Fig.
17). Once the machine powers on, release the safety lock
button and proceed with operation.
Fig. 17
Safety lock
button
12
Safety key
Battery
compartment
cover
On/off
switch lever