Maintenance Tips; Cleaning And Storage; Recycling + Disposal - sunjoe 24V-CRLM15-CT Manual Del Operador

Fig. 18
Paper
Cutting bar
3. All the blades should slice the paper evenly along the
entire length of the cutting bar while the wheel is turned
smoothly. Repeat this testing on the other side of the
mower.
4. If the mower cuts the paper intermittently, use the hex key
wrench provided to tighten the adjustment bolt closest
to where the intermittent cut was observed. Tighten the
bolt on the appropriate end of the cutting bar by turning
it clockwise approximately 1/8th of a turn until the steel
blade contacts the cutting bar (Fig. 19).
Hex key
Adjusting
bolts
5. If it becomes too difficult to move the wheel by hand while
adjusting the reel blades, back off the adjustment bolt
slightly by turning it counterclockwise. Test again with a
new piece of paper to verify proper cutting action.
6. Make the same adjustment at the other end of the cutting
bar.
m
WARNING!
Both adjustment bolts should have tension
on final adjustment. Do not overtighten the adjustment bolts
as this could damage the blades.
NOTE: If you have any questions, please call the Snow Joe
Sun Joe customer service department at 1-866-SNOWJOE
®
(1-866-766-9563) for assistance.

Cleaning and Storage

1. Clean the exterior of the machine thoroughly using a soft
brush and cloth before storing. Do not use water, solvents,
or polishes.
2. Turn the mower on its side to clean the blade area.
Steel blade
m
WARNING!
Turn the
wheel by
cutting area. If grass cuttings are compacted in the blade area,
hand
remove them using a wood or plastic cleaning tool appropriate
for blade cleaning.
3. Store the mower in a dry place. Do not place other objects
on top of the mower during storage.

Maintenance Tips

Reel mowers are relatively low maintenance. For consistent
cutting, follow the below instructions:
• Always keep the cutting blades properly adjusted. Refer to
the instruction manual for further directions.
• Regularly clean and lubricate cutting edges with light spray
oil.
IMPORTANT! Reel mowers have difficulty cutting tall weeds,
such as dandelions, and will often bend, rather than cut, such
weeds. Cut often to prevent this.
Disposal
Recycling the tool
Fig. 19
• Do not dispose of electrical appliances as unsorted
municipal waste. Use separate collection facilities.
• Contact your local government agency for information
regarding the collection systems available.
• If electrical appliances are disposed of in landfills
or dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging your
health and well-being.
• When replacing old appliances with new ones, the retailer
is legally obligated to take back your old appliance for
disposal at least free of charge.

Recycling + Disposal

The product comes in a package that protects it against
damage during shipping. Keep the package until you are
sure that all parts have been delivered and the product is
functioning properly. Recycle the package afterwards or keep
it for long-term storage.
+
®
Battery Caution + Disposal
Always dispose of your battery pack according to federal,
state, and local regulations. Contact a recycling agency in your
area for recycling locations.
14
Do not place your hands inside or near the
WEEE symbol. Waste electrical products should not
be disposed of with household waste. Please recycle
where facilities exist. Check with your local authority
or local store for recycling regulations.