Error Message - NuWave Bravo XL Manual Del Propietário

TROUBLESHOOT GUIDE
White smoke is coming
out of the product.
1. You are cooking greasy
foods. The Cooking
Rack, Stainless-steel
Mesh Rack and Grill/
Griddle contains greasy
residue from previous
uses. When preparing
greasy ingredients in the
Bravo, large amounts
of oil can smoke. The
oil will produce white
smoke. This will not
affect the final cooking
effect. White smoke
is caused by grease
heating up on the
Cooking Rack, Stainless-
steel Mesh Rack, Grill/
Griddle and Crumb Tray.
2. Clean the Cooking Rack,
Stainless-steel Mesh
Rack, Grill/Griddle and
Crumb Tray regularly
between use.
The LED screen is blank.
1. The Bravo overheated
and has shut itself down.
No action was taken after
certain stages of cooking
and Bravo shut down.
Control Panel not working
correctly.
2. Unplug the Bravo and
allow the Bravo to
completely cool. Plug it
back in and see if it is
working. If the LED screen
remains blank, contact
Customer Service at
1-877-689-2838 or email
help@nuwavenow.com.
34 34
troubleshoot guide
The Bravo is not heating.
1. The Bravo is unplugged.
The Bravo has overheat-
ed. Heating elements are
not working.
2. Make sure the Bravo
is plugged in. Make
sure the Bravo is has
completely cooled. Plug
in and see if the Bravo
comes up to the correct
temperature. If the Bravo
still fails to heat up, con-
tact Customer Service at
1-877-689-2838 or email
help@nuwavenow.com.
If the Bravo needs to be
replaced or returned to
the manufacturer, contact
Customer Service at
1-877-689-2838
or email:
help@nuwavenow.com.
TROUBLESHOOT GUIDE

Error Message:

The Probe not connected to the Bravo. Plug
Prb1
the Bravo into the appropriate power socket.
The Probe target internal temperature is set
Prb2
higher than set cooking temperature.
A Probe short Circuit.
Contact Customer Service Department at
Prb3
1-877-689-2838 or help@nuwavenow.com.
The Probe sensor not detecting any
temperature increase. Ensure the Probe is
Prb4
inserted into the food and the food is in oven
during cooking.
The NTC Temperature Sensor has overheated.
Turn the Bravo off to cool. If the Bravo is not
Er1
working after it cools down, contact Customer
Service.
An NTC Temperature Sensor short circuit.
Contact Customer Service Department at
Err1
1-877-689-2838 or help@nuwavenow.com.
The NTC Temperature Sensor is open. Contact
Customer Service Department at 1-877-689-
Err2
2838 or help@nuwavenow.com.
Err8 A button may be jammed.
Solution(s):
35 35
nuwavenow.com nuwavenow.com