Handlebar Adjustment - Matrix S Serie Manual Del Usuario

Handlebar adjustment:

Begin with the top of the handlebar at relatively the same height or just slightly higher than
the top of the saddle (dotted horizontal line A in the drawing below) and at a neutral
fore/aft position (see dotted vertical line B in drawing below). If your knees touch the
handlebars or if you experience back discomfort while pedalling for extended periods of
time, the height of the handlebars can be adjusted. First, dismount the Matrix S-Series
Indoor Cycle.
Next, turn the front adjustment knob counter clockwise, slide the handlebar post up or
down, and then retighten the adjustment knob.
A
Next, the horizontal position of the handlebar should be adjusted. If the handlebar is
too close to the saddle, your breathing may feel restricted; if the handlebar is too far
from the saddle, you may experience back discomfort. To adjust the horizontal position
of the handlebar, fi rst dismount the Matrix S-Series Indoor Cycle. Check for proper handle-
bar position by positioning your elbow so that it is touching the front tip of the saddle at a 90
degree angle and checking that the fi ngertip of your middle fi nger is touching the handlebar
at the mid-point. If it is not as described then loosen the fore/aft lever handle and slide the
handlebar forward or backward until your middle fi nger is touching the handlebar at the mid-
point, and then retighten the lever handle.
The handlebar offers a wide variety of hand positions for personal preferences. Changing
your hand position can change the angle of your back, neck, and arms. To minimize the
stress on your muscles during your workouts, change your hand position frequently.
Version 1.0 2013 IC-MXSB-01 Copyright by Indoorcycling Group GmbH 2013
HOW TO ADJUST THE Matrix S-Series Indoor Cycle
B
|
www.indoorcycling.com
handlebar
fore/aft
lever handle:
handlebar
up/down
adjustment knob
ENG 11