IKEA SÄRDRAG Manual Del Usuario página 11

For typical under counter installation of an electric built-in oven see Figure 11 below.
Only certain cooktop models may be
installed over certain built-in electric oven
models. Approved cooktops and built-in
ovens are listed by the MFG ID number and
product code (see the insert sheet included
in the literature package and cooktop
installation instructions for dimensions).
WARNING!
To reduce the risk of
personal injury and
tipping of the wall
oven, the wall oven
must be secured to
the cabinet(s) by
mounting screws.
208/240 Volt
junction box
for built-in
oven.
Cut an opening in wood base minimum
4" x 4" (10.2 X 10.2 cm), 2" (5 cm) from
left side filler panel, to route armoured
cable to junction box.
30" (76.2 cm)
Wall Oven
Figure 11- TYPICAL UNDER COUNTER INSTALLATION OF A SINGLE
ELECTRIC BUILT-IN OVEN WITH AN ELECTRIC COOKTOP MOUNTED ABOVE
Note 1: 4" x 4" (10.2 X 10.2 cm) opening to route
armoured cable from cooktop to junction box.
Approx. 3"
(7.5 cm)
Approx. 3"
(7.5 cm)
See
Note 1
Unit will
overlap
cutout
(minimum)
edges by
1" (2.5cm)
CUTOUT DIMENSIONS
F. WIDTH
28½" (72.4 cm) Min.
29" (73.7 cm) Max.
208/240Volt
junction box
for Cooktop
5" (12.7 cm)
Max.
G. DEPTH H. HEIGHT
23½" (59.7 cm) 27¼" (69.2 cm) Min.
Min. 28¼" (71.8 cm) Max.
Cabinet side filler
panels are necessary
to isolate the unit
from adjoining
cabinets. Cabinet side
filler height should
allow for installation
of approved cooktop
models
35¾" Min.
(90.8 cm) Min.
Use 3/4" (1.9 cm)
plywood, installed on
two runners, flush with
toe plate. Base must be
capable of supporting
200 pounds (90 kg) for
30" models.
11