Sauder 414435 Manual Del Usuario página 7

Step 3
Flip the SIDE PANEL (G) over. Turn two BLACK 9/16"
å
FLAT HEAD SCREWS (32S) into SIDE PANEL (G) until the
shoulders of the SCREWS rest on the surface of it.
Slide the BRACE (I) onto the SIDE PANEL (G). Line up the
å
groove in the MOLDING over the heads of the SCREWS
in the SIDE PANEL.
www.sauder.com/services
G
After sliding on the BRACE,
these edges should be even.
BLACK 9/16" FLAT HEAD SCREW
(2 used in this step)
After sliding on the BRACE,
these edges should be even.
Shoulder
32S
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
414435
I
G
I
Page 7