Sauder 158082 Manual Del Usuario página 12

Step 7 Step
Fasten six TIE PLATES (3G) to the SHELF MOLDING (M36) and
å
VALANCE (M55). Use six BLACK 9/16" LARGE HEAD SCREWS (1S).
Push a RUBBER SLEEVE (58G) over the TIE PLATES (3G) on the
å
SHELF MOLDING (M36).
Fasten the VALANCE (M55) to the TOP MOLDING (M10). Use two
å
BLACK 9/16" LARGE HEAD SCREWS (1S).
Fasten the END MOLDINGS (P) to the ENDS (A and B) and
å
VALANCE (M55). Use ten BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: There are no holes in the END MOLDINGS (P). Turn the
å
screws into the grooves of the END MOLDINGS. Do not over tighten.
Fasten the SHELF MOLDING (M36) to the ENDS (A and B). Use two
å
BLACK 9/16" LARGE HEAD SCREWS (1S).
These edges must be even.
Page 12
M10
M55
P
B
BLACK 9/16" LARGE HEAD SCREW
(20 used for the ANGLE BRACKETS and TIE PLATES)
P
A
M36
1S
158082
3G
M55
3G
M36
The LARGE RUBBER
SLEEVES should be here.
www.sauder.com/services
58G
This hole
is closer to
this edge.