Publicidad
Problem
No bubbles
Bubble solution is leaking
from the mower
Bubble solution is foaming
Solution
There is not enough bubble solution in the bubble chamber.
Press down on bubble solution bottle for 15 seconds to refill.
The bubble chamber is clogged. Follow instructions in "Let's Clean Up"
section to clean bubble chamber thoroughly.
The bubble mower needs to be pushed a minimum of 15-20 walking
steps before bubbles begin to flow.
You may be walking too quickly. Walk at a slow, steady pace.
The rear wheels aren't on the ground. Push the mower so that the rear
wheels always contact the ground.
Silicone or oily lubricants may have gotten in the bubble chamber.
Never use silicone or oily lubricants on this product (the wheels).
Bubbles will not form if even a very small amount of these substances
get into the bubble chamber.
Bubble chamber is overfilled. Fill only by using filler cap. The filler cap
dispenses the correct amount of solution.
Use the mower only on flat, level ground.
The bubble chamber is clogged. Follow instructions in "Let's Clean Up"
section to clean bubble chamber thoroughly.
7
Publicidad
