Elcometer 3000 Guia Del Usuario página 10

6 TESTING A SAMPLE - MOTORISED CLEMEN UNIT (cont.)
Part Description
D Hexagonal Wrench; 3mm
E M4 x 20 Screw for Load Beam
F M4 x 25 Screw for Sample Clamp
G Height Adjustable Wheel
Fit the parts in accordance with the recommendations given in the
table below.
Sample Thickness
mm inches
0.5 - 5 0.02 - 0.2
5 - 10 0.2 - 0.4
10 - 15 0.4 - 0.6
15 - 20 0.6 - 0.8
Note:
1) Fit the load beam base and sample clamp to the spacers using screws of an appropriate length
(Parts E & F above).
2) Use the height gauge (Part C above) to adjust the height of the nylon wheel and then tighten the
knurled wheel to lock in place.
www.elcometer.com
5mm Spacers for
Load Beam Base (Qty)
0
1
2
3
12mm Spacer for
Sample Clamp
Not Required
Not Required
Required
Required
R
Qty
1
4 sets
2 sets
1
A + E
G + C
B + F
Height Gauge
for Wheel
5mm
10mm
15mm
20mm
en-8