Getting Started; Testing A Sample - Manual Clemen Unit - Elcometer 3000 Guia Del Usuario

3 WORKING SAFELY (continued)
The IEC inlet is protected by one fuse - see Section 10 'Technical
Specification' on page en-10 for fuse rating.
The UK mains plug is fitted with a fuse. When replacing this fuse,
ensure a fuse of the correct rating is used - see Section 10 'Technical
Specification' on page en-10 for details.
Elcometer recommends using mains leads approved by a recognised
testing authority. Examples of suitable mains leads are UK, EUR
H05RN-F 3G 0.75mm 2 cable, US SJT 18AWG/3C cable.

4 GETTING STARTED

4.1 INSTALLATION
The Elcometer 3000 Motorised Clemen Unit is heavy; manual
lifting of the tester must be carried out by at least two people.
Place the Elcometer 3000 on a flat level surface suitable for the load
imposed by the tester. The Elcometer 3000 Motorised Clemen Unit
has adjustable feet which can be used to level the tester.
4.2 SWITCHING ON / OFF - MOTORISED CLEMEN UNIT ONLY
Press the On/Off button to switch the unit on. The button will
illuminate when the unit is switched on. Press the On/Off button again
to switch the unit off.

5 TESTING A SAMPLE - MANUAL CLEMEN UNIT

Before a sample can be tested, the height of the tool must be adjusted.
5.1 ADJUSTING THE TOOL HEIGHT
1 Place the sample onto the sample platform and fix into position by
rotating the clamp handle.
2 Lift and hold the load beam in its raised position and slide the
sample platform until the centre of the sample is underneath the
tool.
www.elcometer.com
R
en-4