Kohler K-124 Guia De Instalacion página 5

Elbow
Elbow
3. Complete the Valve Installation
NOTE: This section applies to all valve installation styles.
CAUTION: Risk of product damage. Remove the plaster guards,
valve units, and aspirator before applying heat to the yoke.
IMPORTANT! Use thread sealant on all threaded connections.
Remove the plaster guards, valve units, and aspirator.
Plumb using 1/2" copper tubing, elbows, and adapters.
Reinstall the plaster guards, valve units, and aspirator.
Secure the bath and shower piping to the support framing and
install temporary nipples.
Install the provided plug in the appropriate valve body outlet if
the installation is for bath or shower only.
Close the valves (cold = counterclockwise, hot = clockwise).
Turn on the main water supply.
Turn on the water to flush debris from valve and check for leaks.
Turn off water.
Complete the finished wall.
Kohler Co.
Temporary
Nipple
1/2" Copper
Tubing
Adapters
1/2" Copper
Tubing
Temporary
Nipple
5 117061-2-A