Light Kit Assembly - Craftmade Ellington Metron Guia De Instalacion

9. Light Kit Assembly.

Remove 1 screw from fitter plate on underside
of motor and partially loosen the other 2 screws,
save screws to attach LED light kit.
Connect WHITE wire from motor housing to
WHITE wire from light kit fitter. Connect BLACK
wire from motor housing to BLACK wire from
light kit fitter. Be sure molex connections snap
together securely.
Carefully arrange wiring in opening in center of
light kit fitter.
Align slotted holes in light kit fitter with the
loosened screws in fitter plate. Twist light kit
fitter to lock. Re-insert screw that was just
removed and securely tighten all 3 screws.
Install two 13-watt medium base compact
fluorescent bulbs (included). Align grooves on
glass shade with nodules on inside of light kit
fitter and push up gently on glass shade. Twist
glass shade to the RIGHT (clockwise) until glass
shade locks into place. Pull down VERY GENTLY on
glass shade to make sure that glass shade is
secure.
IMPORTANT: When you need to replace the
bulb, please allow bulb and glass shade to cool
down before touching.
motor plate
male plug
female plug
page 8
male plug
fitter
plate
motor housing
fitter plate
LED light kit
nodules
glass shade