10. Remote Control Assembly./Automated Learning Process.
remote control
2
III
IV
II
1
I
4
Fan SPEED control buttons1:
Fan OFF button 2:
REVERSE function button 3:
LIGHTING button 4:
ON/OFF slider switch 5:
11. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Locate ON/OFF slider switch on wall control and set
to the ON position. Test fan speeds and light function. Locate
remote control transmitter. Test fan speeds with the different
fan speed buttons (I - VI) on remote control. If the remote
control operates all of the functions of the fan, battery has been
installed correctly. If the wall and/or remote controls do (does)
not operate all of the fan functions, refer to "Troubleshooting"
section to solve any issues before contacting Customer Service.
Fan must be on LOW before setting the fan in reverse. Use
button to recirculate air depending on the season. A ceiling fan
will allow you to raise your thermostat setting in summer and
lower your thermostat setting in winter without feeling a
difference in your comfort.
NOTE: If the wall/remote control interferes with other
appliances, change code switches on the wall/remote control to
another code. If you do change the code, turn power off first.
After setting the new code on the wall/remote control, go back
to the instructions for SET button in Section 10
(page 9).
IMPORTANT: Remote and wall controls must be synchronized
with fan in order to properly function.
IMPORTANT:
Remote and wall
controls must be
V
SYNCHRONIZED with
VI
fan in order to
properly function.
Use to control the ceiling fan speed 1-6
Use to turn the fan off
Use to control fan direction
Use to control down-light and up-light (if applicable)
[Wall control only] Use to turn wall control on or off
page 10
wall control
2
III IV
1
II
V
I
VI
3
4
5
OFF
ON
IV
III
II
V
VI
I