Conceptronic CMED2PLAY Guía De Instalación Rápida página 30

ENGLISH
When you are looking at the photos in full screen view the device will change to the next photo
automatically (auto slide show feature). The interval time between the two photos can be
changes by pressing the 'Delay' button. The default interval time can be set via Setup Menu
Slideshow Setup
Slideshow setup
buttons to view the previous / next photo.
Transition mode
While viewing photos you can use the TRANS button to change the transition MODES. There
are 14 modes:
MODE 1: FULL SCREEN
MODE 2: RANDOM
MODE 3: ROLL: TOP TO BOTTOM
MODE 4: ROLL: bottom to top
MODE 5: ROLL: TOP/BOTTOM TO CENTER
mode 6: ROLL: center to Top/Bottom
MODE 7: BLIND: TOP TO BOTTOM
MODE 8: ROLL: LEFT TO RIGHT
MODE 9: ROLL: RIGHT TO LEFT
MODE 10: ROLL: LEFT/RIGHT TO CENTER
MODE 11: ROLL: CENTER TO LEFT/RIGHT
MODE 12: ROLL: IMPLODE
MODE 13: BLIND: LEFT TO RIGHT
MODE 14: CROSS FADE
The default transition mode can be set via Setup Menu
Photo rotation
While playing back photos, you can use the ROTATE button to turn around photos. By default
the rotation message of the photos is kept until you turn off the device or switch to standby
mode. If you do not want to keep the rotation message, you can disable this function via Setup
Menu Photo Setup
Photo zoom
Press the ZOOM button to enter or exit ZOOM mode to change the zoom ratio. When a photo
is enlarged, you can use the
Interval Time. The auto slide function can be disabled via Setup Menu
Manual. When auto slide show is disabled you can use the
Orientation Off.
/ / / buttons to move it.
Slideshow setup
30
/
Transition