IKEA LAGAN Manual De Instrucciones página 13

8. Adjust LOW setting of surface
burner valves (linear flow).
Test to verify if LOW setting should be
adjusted:
a. Push in and turn control to LITE until burner
ignites.
b. Push in and quickly turn knob to lowest position.
c. If burner goes out, reset control to OFF.
d. Remove the surface burner control knob.
e. Insert a thin-bladed screwdriver into the hollow
valve stem and engage the slotted screw inside.
Flame size can be increased or decreased with
the turn of the screw (see Fig. 17 and Fig. 18).
f. Adjust flame until you can quickly turn
knob from LITE to lowest position without
extinguishing the flame. Flame should be as
small as possible without extinguishing.
Note: Air mixture adjustments are not required on
surface burners.
Fig. 17
Burner flame size
5/8"
Fig. 18
9. Check ignition of oven burners.
The operation of oven igniters should
be checked after range and supply line
connectors have been carefully checked for
leaks and range has been connected to electric
power. Be sure all packing materials and
literature are removed from oven.
The oven burner is equipped with an electric control
system as well as an electric oven burner igniter. If
your model is equipped with an upper oven burner,
it will also have an electric burner igniter. These
control systems require no adjustment. When
the oven is set to operate, current will flow to the
igniter. It will "glow" similar to a light bulb. When
the igniter has reached a temperature sufficient
to ignite gas, the electrically controlled oven valve
will open and flame will appear at the oven burner.
There is a time lapse from 30 to 60 seconds after
the thermostat is turned ON before the flame
appears at the oven burner. When the oven reaches
the set temperature, the glowing igniter will cycle
off. The burner flame will turn off in 20 to 30
seconds after the igniter turns off. To maintain any
set oven temperature, this cycle will continue as
long as the oven control is set to operate.
To check oven burner ignition:
a. Set oven to Bake at 300ºF. See User manual
for operating instructions.
b. Within 60 seconds the oven burner should
ignite. Check for proper flame, and allow the
burner to cycle once. Reset control to OFF.
c. If your model is equipped with a waist-high
broiler, set oven to Broil. See User manual for
operating instructions.
d. Within 60 seconds the broil burner should ignite.
Check for proper flame. Reset control to OFF.
Cooktop
13